CCNP Service Provider 350-501 Real Exam Questions and Answers FREE Updated on Nov 05, 2021
350-501 Ultimate Study Guide - Prep4SureReview
NEW QUESTION 17 
Refer to the exhibit. An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?
- A.
- B.
- C.
- D.
Answer: B
Explanation:
Section: MPLS and Segment Routing
Explanation/Reference:
NEW QUESTION 18
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS, the BGP route reflector feature must be disabled
- B. To support seamless MPLS. TDP must be used as the label protocol
- C. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- D. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
Answer: C
NEW QUESTION 19
O: 22
Which regular expression query modifier function indicates the start of a string?
- A. $
- B. +
- C. ^
- D. [^]
Answer: C
NEW QUESTION 20
Refer to the exhibit:
An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION 21
Refer to the exhibit:
Which effect of this configuration is true?
- A. It enables MPLS on the interface
- B. It enables tagging for VLAN 12 on the interface
- C. It enables AToM on interface gigabitethemet1/0
- D. it creates a pseudowire class named Cisco
Answer: C
NEW QUESTION 22
An engineer implemented LDP protocol on the ISP network. The engineer must ensure that there are no packet loss issues when IGP and LDP protocols are not synchronized. Which configuring must the engineer implement so that the IGP routing protocol will wait until LDP convergence is completed?
- A. Configure LDP sessions protection on the network.
- B. Disable MPLS LDP IGP synchronization on the network.
- C. Configure MPLS LDP IGP synchronization on the network.
- D. Disable IP CEF on routers running LDP and enable LDP protocol.
Answer: C
NEW QUESTION 23
Refer to the exhibit.
Which configuration must be applied to each of the four routers on the network to reduce LDP LIB size and advertise label bindings for the /32 loopback IP space only?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION 24
Refer to the exhibit.
An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN
4567?
- A. Configure an AS path prepend on the peer to ASN 4567.
- B. Configure a high med on the peer to ASN 4567.
- C. Configure a low weight on the peer to ASN 4567.
- D. Configure a high weigh! on ihe peer to ASN 4567.
Answer: D
NEW QUESTION 25
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION 26
Refer to the exhibit:
It the NetFlow configuration is updated to version 9, which additional piece of information can be reported"?
- A. flow sequence numbers
- B. BGP AS information
- C. IPv6 flow information
- D. IPv4 flow information
Answer: C
NEW QUESTION 27
Refer to the exhibit.
A network operator needs to shut down interface Gi0/0/0/2 for maintenance. What occurs to the interface states of Gi0/0/0/0 and Gi0/0/0/1?
- A. Gi0/0/0/0 becomes active. Gi0/00/1 remains standby
- B. Gi0/0/0/1 and Gi0/0/0/0 become active
- C. Gi0/0/0/1 and Gi0//0/0 remains standby
- D. Gi0/0/0/1 becomes active Gi0/0/0/0 remains standby
Answer: A
NEW QUESTION 28
An engineer is implementing a router redistribution within BGP. The route map must be configured to permit all unmatched routes. Which action must the engineer perform to complete this task?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 29
Refer to the exhibit.
What does the script configure?
- A. a static VLAN
- B. a VLAN namespace
- C. a physical domain
- D. selectors for the in-band management
Answer: A
NEW QUESTION 30
What does DWDM use to combine multiple optical signals?
- A. IP protocols
- B. time slots
- C. wavelength
- D. frequency
Answer: C
NEW QUESTION 31
Refer to the exhibits:
R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically Based on this output, which statement is true?
- A. IS-IS neighbor authentication is failing for Level 2 first and then for Level 1 PDUs
- B. IS-IS neighbor authentication is failing for Level 2 PDUs only.
- C. IS-IS neighbor authentication is failing for Level 1 PDUs only
- D. 1S-1S neighbor authentication is failing for Level 1 and Level 2 PDUs .
Answer: C
NEW QUESTION 32
......
Ultimate Guide to Prepare 350-501 Certification Exam for CCNP Service Provider: https://www.prep4surereview.com/350-501-latest-braindumps.html
Use Real 350-501 Dumps - Cisco Correct Answers: https://drive.google.com/open?id=14f4AHw3U_prMiSBf-2SNciUVLGavEo6x
